Linked In

Google Map

Boilers And Heater Auxiliaries

ACCESSORIES / AUXILLURIES

  1. SILENCER–STEAM BLOW OFF:
    1. Design based on diffusion & absorption principle
    2. Design from 1 TPH to 50 TPH capacity up to 110 bar & 540°C
    3. Satisfy OSHA norms for acceptable noise level (dB)
    4. On safety valve discharge, Startup vents discharge, blow down vent discharge
  2. ECONOMIZER:
    New or Replacement of economizers for improving efficiency, increasing steam generation, de-bottle necking of existing system From 10 TPH to 200 TPH Boiler.

    1. PLAIN TUBE: Horizontal vertical construction for dusty gases with combinations of cross & parallel flow.
      Application: Bio mass & fossil fuel fired boiler, Metallurgical, Petrochemical industry of gases.
    2. FIN TUBE: Horizontal vertical construction for clean gases with combinations of cross & parallel flow. With helical welded, helical press fitted, square fin, double H fin, Stud constructions.
      Application: Clean Fossil fuel fired boilers, DG Set, Gas Turbine of gases, Fired Heater waste etc.
    3. CI GILL TUBE: Horizontal construction for corrosive gases with combinations of cross & parallel flow.
      Application: Sulfurous fuel fired boiler & Waste gases.
  3. SUPER HEATER:
    New or Replacement of Super heater for improving efficiency, increasing steam generation, de-bottle necking & increasing temperatures of existing system from 10 TPH to 200 TPH Boiler.

    1. Single stage design
    2. Two stage design
    3. Three stage design
    4. Four stage design
  4. AIR PREHEATER:
    New or Replacement of Air heater for improving efficiency, increasing steam generation, de-bottle necking & increasing temperatures of existing system. Wide verities of configurations like vertical, horizontal & combination, parallel flow, cross flow & combination from 01 TPH to 200 TPH Boiler.

    1. Plain Tube
    2. Cast Iron
    3. Plate Type
    4. Glass Type
  5. STEAM COIL AIR PREHEATER:
    For preheating of atmospheric air before entering to waste heat air Preheater & heating air to very high temperature for direct combustion or process use.
    From 1 mkcal/hr to 10 mkcal/hr heat duty.
  6. DEHUMIDIFIER:
    To remove moisture from atmospheric air for Food & Pharma industry.
    From 1 mkcal/hr to 5 mkcal/hr heat duty.
  7. DEAREATOR:
    Up to 200 TPH capacities at 0.005 PPM residual O2 level & up to 168°C.
  8. LP & HP HEATERS:
    Design based on HEI & TEMA (IBR, ASME Sec-VIII) guidelines up to 50 MW plant.
  9. CONDENSERS:
    Design based on HEI & TEMA (ASME Sec-VIII) guidelines up to 50 MW plant.
  10. RECIPROCATING GRATE:
    Our own developed Design for Dirtiest fuel (Mustard husk, Paddy straw, EFB etc.) including hydraulic & control system up to 60 mkcal/hr heat release duty.